STAGE 63

 Return to the BUILD


“In this issue, the left rear seat backrest is assembled and attached to the seat base.”

 

Contents


Parts

Materials: The Left Rear Seat Backrest is soft PVC, the Padding is foam, and the other parts are plastic.

Magazine

  • The Series – The Rotten Apples
  • Build Your KI.T.T. – Step by Step
  • Secret Files – Voltage Inductor

Build


Left Rear Seat Backrest

Step 1

Fit the Padding under the rounded tabs of the Left Rear Seat Backrest, as shown:

Step 2

In the same way, fit the Backrest Base into the Left Rear Seat Backrest, again resting underneath the tabs.

The soft PVC of the Seat Base can be spread apart to wrap the tabs and posts around the Frame, as shown:

Step 3

Secure the Backrest Base to the Seat Backrest with six (6) DP screws.

Do not over-tighten these screws as they can twist the soft PVC of the Backrest and make it bulge out of position:

Step 4

Further secure the Base to the Backrest with two (2) NP screws at these locations.

These screws go into the soft PVC of the seat so do not tighten them too much:

Step 5

Fit the two posts of the Backrest Rear into the matching holes of the Backrest Base, as shown:

Secure the Backrest Rear into place with two (2) BP screws:

Step 6

Retrieve your Interior Floor Panel assembly from the previous stage. Fit the two small exposed posts of the Backrest Base into these matching holes of the Floor Panel above Left Rear Seat, as shown:

Secure this Backrest assembly into place from behind with two (2) BP screws:

Thoughts


This work completes our Left Rear Seat! We will follow the same process to add the Right Rear Seat over the next two stages.

Next Up


 Stage 64 – Right Rear Seat Base, Seat Base Frame/Padding

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.